Previous Next

Pmod ACL │ 三軸加速度計模組 │ I²C SPI

Pmod ACL 是一個三軸數位加速度計模組,可為主機板提供相應的輸入。用戶可透過 SPI 或 I2C介面與 Analog Devices ADXL345 通訊,指示 Pmod 的定向角度。

  • 3軸,±2/4/8/16g 加速度計
  • 可自選解析度
  • 活動/非活動監控
  • 單/雙擊與自由落體檢測
  • 適用於各種設計的小型PCB尺寸(2.5cm x 2.0cm)
  • SPI 介面與 2x4 pin I²C 介面的 12 pin Pmod連接器 

 

A data stream setting the threshold activity to a value of 250 mg and Interrupt 1 to be triggered whenever
the X and Y axis exceeds the threshold level through SPI is provided below:

Read/~WriteMulti-byte6-bit Threshold Activity Address
0 0 1 0 0 1 0 0
8 bits of Threshold Activity data (62.5 mg/LSB scale)
0 0 0 0 0 1 0 0
Read/~WriteMulti-byte6-bit Activity/Inactivity Control Address
0 0 1 0 0 1 1 1
Activity/Inactivity Control Settings
ACT ac/dc ACT X ACT Y ACT Z INACT ac/dc INACT X INACT Y INACT Z
0 1 1 0 0 0 0 0
Read/~WriteMulti-byte6-bit Interrupt Enable Address
0 0 1 0 1 1 1 0
8 bits of Which Interrupt Sources Are Enabled
Data Ready Single Tap Double Tap Activity Inactivity Free Fall Watermark Overrun
0 0 0 1 0 0 0 0
 
Pinout Description Table
Pmod Header J1
Pmod Header J2
PinSignalDescription
PinSignalDescriptionPinSignalDescription
1 ~CS Chip Select 7 INT2 Interrupt 2 1, 5 SCL Serial Clock
2 MOSI Master-Out-Slave-In 8 INT1 Interrupt 1 2, 6 SDA Serial Data
3 MISO Master-In-Slave-Out 9 NC Not Connected 3, 7 GND Power Supply Ground
4 SCK Serial Clock 10 NC Not Connected 4, 8 VCC Positive Power Supply
5 GND Power Supply Ground 11 GND Power Supply Ground
6 VCC Power Supply (3.3V) 12 VCC Power Supply (3.3V)
Any external power applied to the Pmod ACL must be within 2.0V and 3.6V; it is strongly recommended that Pmod is operated at 3.3V.

 


  通訊協議/介面:I²C  SPI
  DIGILENT Pmod Interface Specification類型/版本:TYPE 2A / 1.2.0
  產品文件:產品規格原理圖  資源中心
  產品編號:410-097
  線上商店:商品連結  可線上刷卡/享運費補助!