Previous Next

TE0823|Xilinx Zynq UltraScale+ 3CG-L1I,LP

TE0823-MPSoC Module with Xilinx Zynq UltraScale+ 3CG-L1I, 1 GByte LPDDR4, 4 x 5 cm, LP

The Trenz Electronic TE0823-01-3PIU1ML is an industrial-grade MPSoC module integrating a low power Xilinx Zynq UltraScale+ ZU3CG, 1 GByte LPDDR4 SDRAM, 128 MByte Flash memory for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking connections.

All this on a tiny footprint, smaller than a credit card, at the most competitive price. Modules in 4 x 5 cm form factor are fully mechanically and largely electrically compatible among each other.

 

Key Features

General

  • Rugged for shock and high vibration
  • Evenly spread supply pins for good signal integrity
  • Plug-on module with 2 x 100 pin and 1 x 60 pin Razor Beam High-Speed hermaphroditic Terminal/Socket Strips (low profile, 2,5 mm)

SoC/FPGA

  • Xilinx Zynq UltraScale+ XCZU3CG-L1SFVC784I (Low Power)
    • Application Processor: Dual-core ARM Cortex-A53 MPCore
    • Real-Time Processor: Dual-core ARM Cortex-R5 MPCore
  • Package: SFVC784
  • Device: ZU3
  • Engine: CG
  • Speed: -1LI (also non-low power assembly options possible)
  • Temperature range: industrial

RAM/Storage

  • Low power DDR4 on PS with 32 bit data width
  • 128 MByte QSPI boot Flash in dual parallel mode
  • 8 GByte e.MMC memory with 8 bit data width
  • MAC address serial EEPROM with EUI-48 node identity

On Board

  • Lattice LCMXO2
  • PLL SI5338
  • Gigabit Ethernet transceiver PHY
  • Hi-speed USB2 ULPI transceiver with full OTG support

Interface

  • 132 x HP PL I/Os (3 banks)
  • ETH
  • USB
  • 4 GTR (for USB3, SATA, PCIe, DP)
    Four high-speed serial I/O (HSSIO) interfaces supporting following protocols:
    • PCI Express interface version 2.1 compliant
    • SATA 3.1 specification compliant interface
    • DisplayPort source-only interface with video resolution up to 4k x 2k

    • USB 3.0 specification compliant interface implementing a 5 Gbit/s line rate
    • 1 GB/s serial GMII interface
  • 14 x PS MIOs
    • MIO for UART
    • thereof 6 MIO for SD card interface (default configuration)
    • MIO for PJTAG
  • JTAG
  • Ctrl

Power

  • 3.3V-5V main input
  • 3.3V controller input
  • Variable bank I/O power input
  • All power supplies on board

Dimension

  • 4 x 5 cm form factor

Scope of Delivery

  • 1 x TE0823-01-3PIU1ML Trenz Electronic MPSoC module with Xilinx Zynq UltraScale+ ZU3CG (low power) and low profile socket strips

  產品編號:TE0823-01-3PIU1ML

  線上商店: 購買連結 可線上刷卡/享運費補助!